Current Electricity MCQ questions with answers

After SEE Bridge Course · Physics. Below are 10 sample questions from this chapter, each with the correct answer and an explanation. The full set of 2,077 questions is free to practise on Prashnalaya.

Topics covered: Chemical effect of current, Electrical Circuits, Electrical Power, Electrolysis, Electromagnetic induction, Heating effect of current, Kirchhoff's Laws, Magnet and Magnetism, Magnetic flux, Ohm's Law, Resistance and Combination of Resistors, Transformer, Wheatstone Bridge

  1. Q1.
    Which law states that the heat produced in a conductor is proportional to the square of current, resistance, and time?
    • A.Ohm's law
    • B.Faraday's law
    • C.Joule's law of heating
    • D.Kirchhoff's law
    Show answer and explanation

    Answer: C. Joule's law of heating

    Joule's law of heating states that the heat produced in a conductor is given by . It shows that heat depends on current, resistance, and time. Therefore, Joule's law of heating is correct.
  2. Q2.
    The SI unit of electrical energy commonly used in Joule's heating formula is:
    • A.Watt
    • B.Volt
    • C.Ampere
    • D.Joule
    Show answer and explanation

    Answer: D. Joule

    In the heating formula , the heat energy produced is measured in joule. Watt is a unit of power, volt is a unit of potential difference, and ampere is a unit of current.
  3. Q3.
    According to Joule's law, if current through a resistor is doubled, the heat produced in the same time becomes:
    • A.Half
    • B.Double
    • C.Four times
    • D.Unchanged
    Show answer and explanation

    Answer: C. Four times

    Since , heat is proportional to the square of current. If current becomes , then heat becomes . So the heat produced becomes four times.
  4. Q4.
    Which household appliance mainly works on the heating effect of electric current?
    • A.Refrigerator motor
    • B.Door bell
    • C.Electric fan
    • D.Electric iron
    Show answer and explanation

    Answer: D. Electric iron

    An electric iron uses the heating effect of current to produce heat in its element and press clothes. The other devices mainly use motor action or electromagnetism.
  5. Q5.
    If no current flows through a wire, the heat produced in it is:
    • A.Maximum
    • B.Minimum but not zero
    • C.Zero
    • D.Equal to resistance
    Show answer and explanation

    Answer: C. Zero

    From , if , then . Therefore, no heat is produced when no current flows through the wire.
  6. Q6.
    The heating element of an electric heater is usually made of:
    • A.Silver
    • B.Aluminium
    • C.Nichrome
    • D.Copper
    Show answer and explanation

    Answer: C. Nichrome

    Nichrome is commonly used because it has high resistivity, a high melting point, and does not oxidize easily at high temperature. Hence it is suitable for heating elements.
  7. Q7.
    In the formula , the symbol represents:
    • A.Power
    • B.Charge
    • C.Resistance
    • D.Current
    Show answer and explanation

    Answer: C. Resistance

    In Joule's law, is heat, is current, is resistance, and is time. Therefore, stands for resistance.
  8. Q8.
    An electric fuse protects a circuit mainly because of the:
    • A.Heating effect of current
    • B.Chemical effect of current
    • C.Luminous effect of current
    • D.Magnetic effect of current
    Show answer and explanation

    Answer: A. Heating effect of current

    A fuse wire melts when excessive current flows through it. This happens due to the heating effect of electric current. Thus, the fuse works on the heating effect.
  9. Q9.
    Which factor does NOT affect the heat produced in a conductor according to Joule's law?
    • A.Time
    • B.Resistance
    • C.Current
    • D.Colour of wire
    Show answer and explanation

    Answer: D. Colour of wire

    Joule's law is . So heat depends on current, resistance, and time. The colour of the wire does not appear in the formula and does not directly affect the heat produced.
  10. Q10.
    The filament of an electric bulb glows because of:
    • A.Electrostatic effect
    • B.Heating effect of current
    • C.Chemical effect of current
    • D.Cooling effect of current
    Show answer and explanation

    Answer: B. Heating effect of current

    When electric current passes through the high-resistance filament, it becomes very hot and glows. This is due to the heating effect of current.

Practise all 2,077 Current Electricity questions

Instant feedback, explanations, timed mock tests and progress tracking. Free on the web and Android.

Start practising free

More Physics chapters

All After SEE Bridge Course subjects →