Inorganic Chemistry – Metals MCQ questions with answers

CEE Entrance · Chemistry. Below are 10 sample questions from this chapter, each with the correct answer and an explanation. The full set of 1,044 questions is free to practise on Prashnalaya.

Topics covered: Copper: occurrence, extraction and properties, General characteristics and chemical properties of alkali metals; Na, NaOH and Na2CO3, General characteristics of alkaline earth metals, General characteristics of transition metals (3d series), Iron: occurrence, extraction; steel manufacture (basic oxygen and open hearth); corrosion, Mercury: occurrence, extraction; calomel and corrosive sublimate, Metallurgical principles: ores, gangue, flux, slag, concentration methods, Metallurgical processes: calcination, roasting, smelting, bessemerization, aluminothermite, electrochemical reduction, Refining: poling, electro-refinement, zone refining, Shape of complex ions: tetrahedral, square planar and octahedral; crystal field theory, Silver: occurrence, extraction and properties, Zinc: occurrence, extraction and properties; white vitriol

  1. Q1.
    Arrange the following mercury ores/minerals in the order from highest to lowest mercury content by mass: Cinnabar, Calomel, Corrosive sublimate, and Native mercury.
    • A.Corrosive sublimate
    • B.Native mercury
    • C.Calomel
    • D.Cinnabar
    Show answer and explanation

    Answer: A. Corrosive sublimate, B. Native mercury, C. Calomel, D. Cinnabar

    Native mercury is elemental mercury, so it contains 100% Hg. In (cinnabar), mercury contributes a larger fraction than in chloride salts because sulfur is lighter than chlorine. In (calomel), the presence of two chlorine atoms lowers the percentage of mercury, and in (corrosive sublimate), the mercury percentage is still lower. Therefore the correct descending order is Native mercury → Cinnabar → Calomel → Corrosive sublimate.
  2. Q2.
    Arrange the steps involved in extraction of mercury from cinnabar in the correct sequence.
    • A.Collection of liquid mercury
    • B.Roasting in air
    • C.Crushing of ore
    • D.Condensation of mercury vapour
    Show answer and explanation

    Answer: A. Collection of liquid mercury, B. Roasting in air, C. Crushing of ore, D. Condensation of mercury vapour

    First, cinnabar ore is crushed to increase surface area. Then it is roasted in air, where . Mercury is produced as vapour because of its low boiling point. This vapour is then cooled and condensed, and finally the liquid mercury is collected. So the correct sequence is Crushing of ore → Roasting in air → Condensation of mercury vapour → Collection of liquid mercury.
  3. Q3.
    Arrange the following mercury compounds in increasing order of oxidation state of mercury: Mercury metal, Calomel, Cinnabar, Corrosive sublimate.
    • A.Corrosive sublimate
    • B.Mercury metal
    • C.Cinnabar
    • D.Calomel
    Show answer and explanation

    Answer: A. Corrosive sublimate, B. Mercury metal, C. Cinnabar, D. Calomel

    In mercury metal, the oxidation state of Hg is 0. In calomel, , the ion is , so each mercury has an oxidation state of +1. In cinnabar, , sulfur is -2, so mercury is +2. In corrosive sublimate, , each chlorine is -1, so mercury is also +2. Since calomel has +1 and both cinnabar and corrosive sublimate have +2, the increasing order is Mercury metal → Calomel → Cinnabar → Corrosive sublimate.
  4. Q4.
    Arrange the following substances in the correct order corresponding to this reaction pathway during metallurgy of mercury: cinnabar ore, mercury vapor, liquid mercury, sulfur dioxide gas.
    • A.liquid mercury
    • B.sulfur dioxide gas
    • C.cinnabar ore
    • D.mercury vapor
    Show answer and explanation

    Answer: A. liquid mercury, B. sulfur dioxide gas, C. cinnabar ore, D. mercury vapor

    During roasting, cinnabar is the starting material. It decomposes/oxidizes to give mercury in vapour form and sulfur dioxide gas: . Since mercury is formed hot, it first appears as vapour and then condenses to liquid mercury on cooling. Thus the process order centered on mercury recovery is Cinnabar ore → Mercury vapor → Liquid mercury, while sulfur dioxide is the gaseous by-product released during roasting. From the given choices, the best ordered pathway is Cinnabar ore → Mercury vapor → Liquid mercury → Sulfur dioxide gas.
  5. Q5.
    Arrange the following mercury-related substances in order of increasing water solubility: cinnabar, calomel, mercury metal, corrosive sublimate.
    • A.Calomel
    • B.Corrosive sublimate
    • C.Cinnabar
    • D.Mercury metal
    Show answer and explanation

    Answer: A. Calomel, B. Corrosive sublimate, C. Cinnabar, D. Mercury metal

    Mercury metal is essentially insoluble in water. Cinnabar, , is also highly insoluble, but as a sulfide mineral it is generally considered less available to dissolve than calomel only in practical comparison of mercury compounds. Calomel, , is sparingly soluble in water. Corrosive sublimate, , is much more soluble in water than calomel. Therefore the increasing order of water solubility is Mercury metal → Cinnabar → Calomel → Corrosive sublimate.
  6. Q6.
    Arrange the following silver ores in the order of decreasing silver content by mass in the pure mineral: Argentite, Horn silver, Native silver, Pyrargyrite.
    • A.Horn silver
    • B.Argentite
    • C.Pyrargyrite
    • D.Native silver
    Show answer and explanation

    Answer: A. Horn silver, B. Argentite, C. Pyrargyrite, D. Native silver

    Native silver is elemental silver, so it has the highest silver content. Horn silver is , argentite is , and pyrargyrite is . Comparing mass fractions of silver shows: Native silver = 100% Ag, has a higher silver fraction than , and pyrargyrite has the lowest due to antimony and sulfur. Therefore the decreasing order is Native silver > Horn silver > Argentite > Pyrargyrite.
  7. Q7.
    In the extraction of silver from argentite by cyanide process and zinc displacement, arrange the steps in the correct sequence.
    • A.Recovery and purification of silver
    • B.Formation of soluble argentocyanide complex
    • C.Addition of zinc for displacement
    • D.Leaching with dilute in air
    Show answer and explanation

    Answer: A. Recovery and purification of silver, B. Formation of soluble argentocyanide complex, C. Addition of zinc for displacement, D. Leaching with dilute in air

    In the MacArthur-Forrest cyanide process, crushed argentite ore is treated with dilute in presence of air. Silver dissolves as the soluble argentocyanide complex, commonly represented as . Then zinc is added, which displaces silver from the complex. Finally, the silver is collected and purified. Hence the correct order is leaching -> complex formation -> zinc displacement -> recovery.
  8. Q8.
    Arrange the following silver compounds in the order in which they are formed starting from metallic silver during this reaction sequence: silver is treated with dilute , then is added, then excess aqueous is added, and finally the ammoniacal solution is acidified.
    • A. -> -> ->
    • B. -> -> ->
    • C. -> -> ->
    • D. -> -> ->
    Show answer and explanation

    Answer: B. -> -> ->

    Silver reacts with dilute nitric acid to form silver nitrate, . On adding hydrochloric acid, a white precipitate of forms. This dissolves in excess aqueous ammonia due to the formation of the diamminesilver(I) complex, . On acidification, ammonia is neutralized and reappears. So the sequence is -> -> -> .
  9. Q9.
    Arrange the following metals in increasing order of their tendency to displace silver from aqueous : Ag, Cu, Zn, Fe.
    • A.Zn
    • B.Ag
    • C.Fe
    • D.Cu
    Show answer and explanation

    Answer: A. Zn, B. Ag, C. Fe, D. Cu

    A metal higher than silver in the reactivity series can displace silver from solution. Among the given metals, silver itself has no tendency to displace silver. Copper can displace silver, iron does so more readily than copper, and zinc is the most reactive among these. Therefore the increasing order of displacement tendency is Ag < Cu < Fe < Zn.
  10. Q10.
    Arrange the following observations for silver chloride in the correct order when it is exposed to sunlight, then treated with aqueous ammonia, and finally acidified with dilute nitric acid.
    • A.Turns grey/violet in sunlight
    • B.Dissolves in aqueous
    • C.White precipitate reappears on acidification
    • D.White precipitate
    Show answer and explanation

    Answer: A. Turns grey/violet in sunlight, B. Dissolves in aqueous , C. White precipitate reappears on acidification, D. White precipitate

    Fresh silver chloride is a white precipitate. On exposure to sunlight, it undergoes photochemical decomposition and appears grey or violet due to formation of finely divided silver. Silver chloride dissolves in aqueous ammonia by forming the soluble diamminesilver(I) complex. When the solution is acidified with dilute nitric acid, the complex breaks and white precipitates again. Therefore the correct order is white precipitate -> grey/violet in sunlight -> dissolves in ammonia -> white precipitate reappears on acidification.

Practise all 1,044 Inorganic Chemistry – Metals questions

Instant feedback, explanations, timed mock tests and progress tracking. Free on the web and Android.

Start practising free

More Chemistry chapters

All CEE Entrance subjects →