Physical Chemistry – States of Matter (Liquid) MCQ questions with answers

CEE Entrance · Chemistry. Below are 10 sample questions from this chapter, each with the correct answer and an explanation. The full set of 306 questions is free to practise on Prashnalaya.

Topics covered: Liquid crystal; solution and solubility curve, Surface tension and viscosity, Vapour pressure and boiling point

  1. Q1.
    Arrange the following liquids in increasing order of surface tension at about room temperature.
    • A.water
    • B.benzene
    • C.mercury
    • D.ethanol
    Show answer and explanation

    Answer: A. water, B. benzene, C. mercury, D. ethanol

    Surface tension depends on cohesive force between molecules. Ethanol has the lowest surface tension among these, benzene is higher than ethanol, water is much higher because of hydrogen bonding, and mercury is the highest due to very strong metallic cohesion. Therefore the increasing order is ethanol < benzene < water < mercury.
  2. Q2.
    A capillary tube is dipped separately in different liquids at the same temperature. Arrange the liquids in increasing order of capillary rise in a glass tube.
    • A.water
    • B.ethanol
    • C.mercury
    • D.kerosene
    Show answer and explanation

    Answer: A. water, B. ethanol, C. mercury, D. kerosene

    Capillary rise is given by . In glass, mercury shows capillary depression, so it is the least. For liquids that wet glass, the rise depends roughly on . Water rises more than ethanol and kerosene in typical glass capillaries. Thus the increasing order is mercury < kerosene < ethanol < water.
  3. Q3.
    Arrange the following liquids in increasing order of viscosity near room temperature.
    • A.water
    • B.glycerol
    • C.ether
    • D.ethanol
    Show answer and explanation

    Answer: A. water, B. glycerol, C. ether, D. ethanol

    Viscosity is the resistance to flow. Ether flows most easily, so it has the smallest viscosity. Ethanol is slightly more viscous than ether, water is more viscous than ethanol, and glycerol is much more viscous due to strong intermolecular attraction and larger molecular interactions. Hence the increasing order is ether < ethanol < water < glycerol.
  4. Q4.
    Arrange the following processes for a pure liquid in the correct sequence as temperature increases from low to high, focusing on viscosity behavior.
    • A.Intermolecular attraction becomes less effective
    • B.Viscosity decreases
    • C.Random motion increases
    • D.Internal friction decreases
    Show answer and explanation

    Answer: A. Intermolecular attraction becomes less effective, B. Viscosity decreases, C. Random motion increases, D. Internal friction decreases

    When temperature rises, molecules move faster. Because of this increased random motion, cohesive forces become relatively less effective in opposing motion between layers. As a result, internal friction decreases and hence viscosity decreases. Therefore the correct sequence is: random motion increases, intermolecular attraction becomes less effective, internal friction decreases, viscosity decreases.
  5. Q5.
    Arrange the following liquids in increasing order of intermolecular force based on their typical surface tension values at room temperature.
    • A.water
    • B.benzene
    • C.ethanol
    • D.acetone
    Show answer and explanation

    Answer: A. water, B. benzene, C. ethanol, D. acetone

    Greater surface tension generally indicates stronger intermolecular attraction. Acetone has relatively low surface tension, ethanol is higher because of hydrogen bonding but still lower than benzene in typical values, benzene is slightly higher than ethanol, and water is the highest among these due to extensive hydrogen bonding. So the increasing order of intermolecular force inferred from surface tension is acetone < ethanol < benzene < water.
  6. Q6.
    Arrange the following liquids in increasing order of vapour pressure at the same temperature: water, ethanol, diethyl ether, glycerol.
    • A.water
    • B.diethyl ether
    • C.glycerol
    • D.ethanol
    Show answer and explanation

    Answer: A. water, B. diethyl ether, C. glycerol, D. ethanol

    At the same temperature, stronger intermolecular force means lower vapour pressure. Glycerol has very strong hydrogen bonding, so it has the lowest vapour pressure. Water also has strong hydrogen bonding, but less than glycerol. Ethanol has weaker intermolecular attraction than water. Diethyl ether has the weakest intermolecular force among these, so it has the highest vapour pressure. Therefore the increasing order is glycerol < water < ethanol < diethyl ether.
  7. Q7.
    Arrange the following liquids in increasing order of normal boiling point: acetone, water, diethyl ether, ethylene glycol.
    • A.water
    • B.diethyl ether
    • C.ethylene glycol
    • D.acetone
    Show answer and explanation

    Answer: A. water, B. diethyl ether, C. ethylene glycol, D. acetone

    A liquid with weaker intermolecular force boils at a lower temperature. Diethyl ether has weak intermolecular attraction, so it has the lowest boiling point. Acetone has stronger dipole interaction than ether, so its boiling point is higher. Water forms hydrogen bonds, giving a still higher boiling point. Ethylene glycol has two -OH groups and very strong hydrogen bonding, so it has the highest boiling point. Hence the increasing order is diethyl ether < acetone < water < ethylene glycol.
  8. Q8.
    A mountaineer carries water, ethanol, kerosene, and mercury to a high-altitude region where atmospheric pressure is lower than at sea level. Arrange these liquids in increasing order of change in boiling point on going from sea level to high altitude.
    • A.water
    • B.ethanol
    • C.kerosene
    • D.mercury
    Show answer and explanation

    Answer: A. water, B. ethanol, C. kerosene, D. mercury

    When external pressure decreases, boiling point decreases for all liquids. The magnitude of change is generally more noticeable for more volatile liquids because their vapor pressure rises more rapidly near ordinary temperatures. Mercury is least volatile and has an extremely high boiling point, so its boiling point changes least. Kerosene changes more than mercury. Water shows a larger change and is well known to boil below 100^\circ\text{C}$ at high altitude. Ethanol, being more volatile, shows the greatest effect among the given liquids. Therefore, the increasing order of change is mercury < kerosene < water < ethanol.
  9. Q9.
    Arrange the following aqueous solutions in increasing order of vapour pressure at the same temperature: 0.1 M glucose, 0.1 M urea, pure water, 0.1 M . Assume complete dissociation of .
    • A.0.1 M glucose
    • B.pure water
    • C.0.1 M urea
    • D.0.1 M
    Show answer and explanation

    Answer: A. 0.1 M glucose, B. pure water, C. 0.1 M urea, D. 0.1 M

    A non-volatile solute lowers the vapour pressure of solvent. Greater number of dissolved particles causes greater lowering. 0.1 M glucose and 0.1 M urea are both non-electrolytes, so they produce nearly the same number of particles and thus nearly the same vapour pressure lowering. Since an exact ordering is required, they may be placed together conceptually, but among the given options both are written with glucose and urea adjacent. dissociates into two ions, so it lowers vapour pressure more strongly and has the lowest vapour pressure. Pure water has the highest vapour pressure because no solute is present. Thus the increasing order is 0.1 M < 0.1 M glucose < 0.1 M urea < pure water.
  10. Q10.
    Arrange the following statements in the correct logical order for explaining why a liquid boils when heated at constant external pressure. Molecules gain kinetic energy. Vapour pressure of the liquid increases. Vapour pressure becomes equal to external pressure. Bubbles form throughout the liquid and boiling starts.
    • A.Vapour pressure becomes equal to external pressure.
    • B.Molecules gain kinetic energy.
    • C.Bubbles form throughout the liquid and boiling starts.
    • D.Vapour pressure of the liquid increases.
    Show answer and explanation

    Answer: A. Vapour pressure becomes equal to external pressure., B. Molecules gain kinetic energy., C. Bubbles form throughout the liquid and boiling starts., D. Vapour pressure of the liquid increases.

    When a liquid is heated, its molecules absorb energy and their average kinetic energy increases first. As the molecules move faster, more of them can escape from the liquid surface into the vapour state, so the vapour pressure of the liquid increases. Boiling does not start immediately at this stage. A liquid boils only when its vapour pressure becomes equal to the external pressure acting on the liquid. At that point, vapour bubbles can exist throughout the liquid without being crushed by the surrounding pressure, so bubbles form inside the liquid and rise to the surface. Hence the correct logical order is: molecules gain kinetic energy vapour pressure increases vapour pressure equals external pressure boiling starts with bubble formation throughout the liquid.

Practise all 306 Physical Chemistry – States of Matter (Liquid) questions

Instant feedback, explanations, timed mock tests and progress tracking. Free on the web and Android.

Start practising free

More Chemistry chapters

All CEE Entrance subjects →