Physical Chemistry – Chemical Kinetics MCQ questions with answers

CEE Entrance · Chemistry. Below are 10 sample questions from this chapter, each with the correct answer and an explanation. The full set of 581 questions is free to practise on Prashnalaya.

Topics covered: Collision theory, activation energy, threshold energy, activated complex, Factors affecting rate: concentration, temperature, catalyst, surface area, Integrated rate law for zero and first order reactions; half-lives, Order and molecularity of reaction, Rate of reaction, rate expression and rate constant (units), Types of catalysis: homogeneous, heterogeneous, enzyme catalysis

  1. Q1.
    Arrange the following conditions in increasing order of rate for the reaction between marble chips and dilute : large marble chips at , powdered marble at , powdered marble at , powdered marble at with a suitable catalyst.
    • A.powdered marble at
    • B.powdered marble at
    • C.powdered marble at with a suitable catalyst
    • D.large marble chips at
    Show answer and explanation

    Answer: A. powdered marble at , B. powdered marble at , C. powdered marble at with a suitable catalyst, D. large marble chips at

    The reaction rate between marble and dilute depends mainly on surface area, temperature, and catalyst.

    The reaction is:


    To arrange in increasing order of rate, compare the effect of each condition:

    1. **Large marble chips at ** react the slowest because large chips have the **smallest surface area** exposed to the acid. Fewer acid particles can collide with the marble surface at a time.

    2. **Powdered marble at ** reacts faster than large chips at the same temperature because powder has a **much larger surface area**, so more collisions occur per second.

    3. **Powdered marble at ** reacts faster than powdered marble at because increasing temperature increases the **kinetic energy** of particles. This makes collisions more frequent and increases the number of collisions with energy greater than the activation energy.

    4. **Powdered marble at with a suitable catalyst** reacts the fastest because the catalyst provides an **alternative pathway with lower activation energy**, increasing the rate even further.

    So the increasing order of rate is:
  2. Q2.
    For the decomposition of hydrogen peroxide, arrange the following factors in the order that generally gives increasing reaction rate: low temperature without catalyst, high temperature without catalyst, low temperature with , high temperature with .
    • A.high temperature without catalyst
    • B.high temperature with
    • C.low temperature without catalyst
    • D.low temperature with
    Show answer and explanation

    Answer: A. high temperature without catalyst, B. high temperature with , C. low temperature without catalyst, D. low temperature with

    The rate of decomposition of hydrogen peroxide, , increases when either temperature is raised or a catalyst is added. A catalyst such as speeds up the reaction by providing an alternative pathway with lower activation energy, while higher temperature increases the kinetic energy of molecules and the frequency of effective collisions.

    Now compare the four cases:

    1. **Low temperature without catalyst**: this gives the slowest reaction rate because neither factor helps the reaction much.
    2. **High temperature without catalyst**: raising temperature increases the rate, so this is faster than low temperature without catalyst.
    3. **Low temperature with **: the catalyst has a stronger effect on this reaction than temperature increase alone, so this is faster than high temperature without catalyst.
    4. **High temperature with **: both favorable factors are present, so this gives the fastest rate.

    Therefore, the order of increasing reaction rate is:



    So the correct arrangement is:

    low temperature without catalyst high temperature without catalyst low temperature with high temperature with .
  3. Q3.
    A student studies the reaction of zinc with dilute . Arrange the following setups in increasing order of rate: 0.5 M acid with zinc granules, 1.0 M acid with zinc granules, 1.0 M acid with powdered zinc, 1.0 M acid with powdered zinc at higher temperature.
    • A.1.0 M acid with powdered zinc
    • B.1.0 M acid with zinc granules
    • C.1.0 M acid with powdered zinc at higher temperature
    • D.0.5 M acid with zinc granules
    Show answer and explanation

    Answer: A. 1.0 M acid with powdered zinc, B. 1.0 M acid with zinc granules, C. 1.0 M acid with powdered zinc at higher temperature, D. 0.5 M acid with zinc granules

    The rate of reaction between zinc and dilute depends mainly on three factors here: concentration of acid, surface area of zinc, and temperature.

    The reaction is:


    To arrange the setups in increasing order of rate, compare the effect of each factor:

    1. **0.5 M acid with zinc granules**
    This has the lowest acid concentration among the given setups, so there are fewer acid particles per unit volume to collide with zinc. Zinc is also in granule form, which gives smaller surface area than powder. So this is the slowest.

    2. **1.0 M acid with zinc granules**
    Here the acid concentration is higher than 0.5 M, so collisions between acid particles and zinc occur more frequently. Since the zinc is still in granule form, the surface area is unchanged from the previous case. Therefore this is faster than the first setup.

    3. **1.0 M acid with powdered zinc**
    The acid concentration is the same as in the second setup, but powdered zinc has a much larger surface area than granules. Greater surface area means more zinc particles are exposed for collision at the same time, so the reaction becomes faster.

    4. **1.0 M acid with powdered zinc at higher temperature**
    This has the same concentration and surface area advantages as the third setup, and in addition the temperature is higher. Higher temperature increases the kinetic energy of particles, so collisions happen more often and a larger fraction of them are effective. Hence this is the fastest setup.

    Therefore, the increasing order of rate is:
  4. Q4.
    For a gaseous reaction, the relative rates under four conditions are considered. Arrange them in increasing order: low concentration at 300 K, high concentration at 300 K, low concentration at 350 K, high concentration at 350 K. Assume no catalyst and all other factors remain constant.
    • A.high concentration at 300 K
    • B.low concentration at 350 K
    • C.high concentration at 350 K
    • D.low concentration at 300 K
    Show answer and explanation

    Answer: A. high concentration at 300 K, B. low concentration at 350 K, C. high concentration at 350 K, D. low concentration at 300 K

    For a gaseous reaction, the rate increases when concentration increases and also when temperature increases.

    Two main ideas are used:

    1. Higher concentration more molecules per unit volume more frequent collisions faster reaction.
    2. Higher temperature molecules move faster and a larger fraction of collisions have energy greater than activation energy faster reaction.

    Now compare the four conditions:

    - : both concentration and temperature are low, so this gives the slowest rate.
    - : concentration is increased while temperature stays the same, so the rate becomes higher than the first case.
    - : temperature is increased from to , so the rate is higher than at . Under the usual kinetic trend, increasing temperature has a stronger effect than only increasing concentration, so this is faster than high concentration at .
    - : both concentration and temperature are high, so this gives the fastest rate.

    Therefore, the increasing order of rate is:



    So the correct arrangement is:
    .
  5. Q5.
    Arrange the following industrial or laboratory changes according to increasing effectiveness in speeding up a reaction: adding an appropriate catalyst, finely grinding a solid reactant, increasing concentration of a reactant, increasing temperature significantly. Consider their usual general effect, not a specific numerical case.
    • A.increasing concentration of a reactant
    • B.adding an appropriate catalyst
    • C.increasing temperature significantly
    • D.finely grinding a solid reactant
    Show answer and explanation

    Answer: A. increasing concentration of a reactant, B. adding an appropriate catalyst, C. increasing temperature significantly, D. finely grinding a solid reactant

    The reaction rate increases when the number of effective collisions increases or when more particles are able to cross the activation energy barrier.

    To compare these changes in a general way:

    1. **Finely grinding a solid reactant** usually gives the smallest general increase.
    - Grinding increases the **surface area** of a solid.
    - More surface area means more particles are exposed for collision.
    - This helps mainly in reactions involving a solid, so its effect is useful but comparatively limited.

    2. **Increasing concentration of a reactant** usually gives a stronger effect.
    - Higher concentration means more particles are present in a given volume.
    - This increases the **frequency of collisions**, so the reaction rate rises.

    3. **Adding an appropriate catalyst** often increases the rate even more.
    - A catalyst provides an **alternative pathway** with lower activation energy.
    - Because of this, a much larger fraction of collisions becomes effective.
    - In many reactions, this can produce a very large increase in rate.

    4. **Increasing temperature significantly** is usually taken as the strongest general effect.
    - Higher temperature increases particle kinetic energy.
    - Collisions become more frequent and, more importantly, a much greater fraction of molecules has energy greater than the activation energy.
    - Even a moderate temperature rise can greatly speed up a reaction.

    So, in order of **increasing effectiveness in speeding up a reaction**:

  6. Q6.
    Arrange the following reactions in increasing order of molecularity: , , , . Arrange from lowest to highest molecularity.
    • A.
    • B.
    • C.
    • D.
    Show answer and explanation

    Answer: A. , B. , C. , D.

    Molecularity is the number of reacting particles taking part in a single elementary step. To arrange the reactions in increasing order, count the number of reactant species on the left side of each reaction.

    1.

    Only one molecule of decomposes, so its molecularity is 1.
    This is a unimolecular reaction.

    2.

    Two reacting species, and , combine.
    So its molecularity is 2.
    This is a bimolecular reaction.

    3.

    Two molecules of are involved.
    So its molecularity is also 2.
    This is also bimolecular.

    4.

    Here, two molecules of and one molecule of participate, making a total of 3 reacting molecules.
    So its molecularity is 3.
    This is a termolecular reaction.

    Therefore, the increasing order of molecularity is:



    So the correct arrangement is:



    Since both and are bimolecular, either order between these two is acceptable if a strict sequence is required.
  7. Q7.
    For a reaction with rate law Rate = , arrange the following in increasing order: order with respect to A, order with respect to B, overall order, order with respect to C.
    • A.overall order
    • B.order with respect to C
    • C.order with respect to A
    • D.order with respect to B
    Show answer and explanation

    Answer: A. overall order, B. order with respect to C, C. order with respect to A, D. order with respect to B

    In a rate law, the order with respect to each reactant is the exponent of its concentration term.

    Given:


    So:
    - Order with respect to
    - Order with respect to
    - Order with respect to

    The overall order is the sum of all exponents:

    So overall order .

    Now arrange these in increasing order of their numerical values:


    Therefore, the correct sequence is:
    - order with respect to A
    - order with respect to B
    - order with respect to C
    - overall order
  8. Q8.
    Arrange the following reactions in increasing order of overall order based on the given rate laws: Rate = , Rate = , Rate = , Rate = .
    • A.Rate =
    • B.Rate =
    • C.Rate =
    • D.Rate =
    Show answer and explanation

    Answer: A. Rate = , B. Rate = , C. Rate = , D. Rate =

    The overall order of a reaction is found by adding the exponents of all concentration terms in its rate law.

    Now calculate each one:

    1. For Rate =
    - Exponent of is
    - Overall order

    2. For Rate =
    - Exponent of is
    - Overall order

    3. For Rate =
    - Exponent of is
    - Exponent of is
    - Overall order

    4. For Rate =
    - Exponent of is
    - Exponent of is
    - Overall order

    So, in increasing order of overall order:



    Hence the correct arrangement is:
    Rate = , Rate = , Rate = , Rate = .
  9. Q9.
    Arrange the following statements from the least to the greatest numerical value of order of reaction: rate is independent of concentration, rate is directly proportional to concentration, rate is proportional to square of concentration, rate is proportional to cube of concentration.
    • A.rate is proportional to cube of concentration
    • B.rate is directly proportional to concentration
    • C.rate is independent of concentration
    • D.rate is proportional to square of concentration
    Show answer and explanation

    Answer: A. rate is proportional to cube of concentration, B. rate is directly proportional to concentration, C. rate is independent of concentration, D. rate is proportional to square of concentration

    The order of a reaction tells how the rate depends on concentration.

    Using the rate law:

    where is the order of reaction.

    Now match each statement with its numerical order:

    - If the rate is independent of concentration, then

    so the order is .

    - If the rate is directly proportional to concentration, then

    so the order is .

    - If the rate is proportional to the square of concentration, then

    so the order is .

    - If the rate is proportional to the cube of concentration, then

    so the order is .

    Arranging from least to greatest numerical value of order:


    So the correct sequence is:
    1. rate is independent of concentration
    2. rate is directly proportional to concentration
    3. rate is proportional to square of concentration
    4. rate is proportional to cube of concentration
  10. Q10.
    The decomposition of a reactant follows different possible rate laws used in kinetics analysis. Arrange the following rate laws in increasing order of half-life dependence on initial concentration: zero-order, first-order, second-order. Use the fact that for zero-order , for first-order is independent of , and for second-order .
    • A.second-order
    • B.zero-order
    • C.first-order
    Show answer and explanation

    Answer: A. second-order, B. zero-order, C. first-order

    The half-life dependence on initial concentration for each rate law is:

    - Second-order:
    - First-order: is independent of
    - Zero-order:

    To arrange them in increasing order of dependence on initial concentration, we go from negative dependence to no dependence to positive dependence:

    1. second-order: half-life decreases as increases
    2. first-order: half-life does not change with
    3. zero-order: half-life increases as increases

    So the correct order is:

    second-order first-order zero-order

Practise all 581 Physical Chemistry – Chemical Kinetics questions

Instant feedback, explanations, timed mock tests and progress tracking. Free on the web and Android.

Start practising free

More Chemistry chapters

All CEE Entrance subjects →