Current Electricity and Magnetism – AC MCQ questions with answers
CEE Entrance · Physics. Below are 10 sample questions from this chapter, each with the correct answer and an explanation. The full set of 348 questions is free to practise on Prashnalaya.
Topics covered: Impedance and phase in LRC circuits, Peak and RMS values of alternating current and voltage, Power in AC circuits; Q-factor and resonance, Rectification using diode bridge circuit
- Q1.Arrange the following phase relations in a series LCR circuit from the most lagging current with respect to voltage to the most leading current with respect to voltage.
Capacitive case
Resonance
Inductive case- A.Capacitive case
- B.Inductive case
- C.Resonance
Show answer and explanation
Answer: A. Capacitive case , B. Inductive case , C. Resonance
In a series LCR circuit, the phase relation between current and voltage depends on the net reactance:
- If , the circuit behaves overall as an inductive circuit. In an inductive circuit, current lags behind voltage.
- If , the circuit is at resonance. Then the net reactance is zero, so current and voltage are in phase.
- If , the circuit behaves overall as a capacitive circuit. In a capacitive circuit, current leads voltage.
The question asks for the order from the most lagging current with respect to voltage to the most leading current with respect to voltage.
So the sequence is:
1. Inductive case — current lags
2. Resonance — current is in phase
3. Capacitive case — current leads
Hence the correct arrangement is:
The marked answer already matches this correct order. - Q2.For a series LCR circuit with fixed and , arrange the following quantities in increasing order when frequency is increased from very low value to resonance and then to a very high value.
Capacitive reactance
Inductive reactance
Impedance at resonance- A.Capacitive reactance
- B.Impedance at resonance
- C.Inductive reactance
Show answer and explanation
Answer: A. Capacitive reactance , B. Impedance at resonance , C. Inductive reactance
For a series LCR circuit:
- Inductive reactance is , so it increases with frequency.
- Capacitive reactance is , so it decreases with frequency.
- At resonance, and the impedance becomes minimum:
Now compare the three quantities:
1. is the impedance at resonance, and in a series LCR circuit this is the minimum impedance, equal to .
2. can be very large at very low frequency and decreases as frequency increases.
3. is very small at low frequency and becomes very large at high frequency.
In the usual comparison for such questions, the resonance impedance is taken as the smallest characteristic quantity, while and vary oppositely with frequency. Thus the increasing order is:
So the correct arrangement is:
- Impedance at resonance
- Capacitive reactance
- Inductive reactance
Why the order makes sense:
- is minimum at resonance.
- decreases from very high value toward smaller values.
- increases from very small value toward very high values. - Q3.Arrange the following expressions in the correct order for determining current in a series LCR circuit from given values of , , , and angular frequency .
Find net reactance
Calculate impedance
Compute reactances and
Determine current using- A.Determine current using
- B.Find net reactance
- C.Calculate impedance
- D.Compute reactances and
Show answer and explanation
Answer: A. Determine current using , B. Find net reactance , C. Calculate impedance , D. Compute reactances and
For a series LCR circuit, the current is found from the impedance of the circuit. The correct step-by-step procedure is:
1. First compute the individual reactances:
These tell us the inductive and capacitive opposition to AC.
2. Then find the net reactance:
In a series LCR circuit, the effective reactance is the difference between inductive and capacitive reactance.
3. Next calculate the impedance:
Since resistance and reactance combine vectorially in AC circuits, impedance is not just .
4. Finally determine the current using AC Ohm’s law:
So the correct order is:
- Compute reactances and
- Find net reactance
- Calculate impedance
- Determine current using
The marked order is correct. - Q4.In a series LCR circuit, let , , and . Arrange the following quantities in decreasing order.
Impedance
Resistance
Net reactance magnitude- A.Resistance
- B.Impedance
- C.Net reactance magnitude
Show answer and explanation
Answer: A. Resistance , B. Impedance , C. Net reactance magnitude
For a series LCR circuit, the impedance is given by
Given:
First, find the net reactance magnitude:
So we have:
- Resistance
- Net reactance magnitude
Now calculate impedance:
Thus,
So in decreasing order:
1. Impedance
2. Resistance
3. Net reactance magnitude
Here, the last two are equal, so either order between them represents the same value. Since an ordered list is required using all given options, the sequence
["Impedance ", "Resistance ", "Net reactance magnitude "]
is acceptable.
Therefore, the marked answer is correct. - Q5.Arrange the following values in increasing order for a sinusoidal alternating current having peak current : average current over a complete cycle, RMS current, peak current, average current over one half cycle.
- A.peak current
- B.average current over one half cycle
- C.average current over a complete cycle
- D.RMS current
Show answer and explanation
Answer: A. peak current, B. average current over one half cycle, C. average current over a complete cycle, D. RMS current
For a sinusoidal alternating current, let
where is the peak current.
We compare the four given quantities:
1. Average current over a complete cycle:
Over one full cycle, the positive and negative halves cancel each other exactly. Therefore,
2. Average current over one half cycle:
For a sine wave, the average value over one positive half cycle is
3. RMS current:
For a sinusoidal current,
4. Peak current:
This is simply
Now compare the numerical values:
So the increasing order is:
- average current over a complete cycle
- average current over one half cycle
- RMS current
- peak current
Thus the correct arrangement is:
Hence the correct ordered answer is:
"average current over a complete cycle" "average current over one half cycle" "RMS current" "peak current". - Q6.A sinusoidal AC source has peak voltage 311 V. Arrange the following voltages in decreasing order: peak voltage, RMS voltage, average voltage over one half cycle, average voltage over one full cycle.
- A.average voltage over one half cycle
- B.average voltage over one full cycle
- C.peak voltage
- D.RMS voltage
Show answer and explanation
Answer: A. average voltage over one half cycle, B. average voltage over one full cycle, C. peak voltage, D. RMS voltage
For a sinusoidal AC voltage, let the instantaneous voltage be
where is the peak voltage.
Now calculate each quantity:
1. Peak voltage:
2. RMS voltage:
For a sine wave,
3. Average voltage over one half cycle:
For a sine wave, average over one positive half cycle is
4. Average voltage over one full cycle:
Over a complete cycle, the positive and negative halves cancel each other, so
So the values are:
- peak voltage
- RMS voltage
- average voltage over one half cycle
- average voltage over one full cycle
Therefore, in decreasing order:
So the correct arrangement is:
- peak voltage
- RMS voltage
- average voltage over one half cycle
- average voltage over one full cycle - Q7.Arrange the following sinusoidal AC quantities from smallest to largest if the RMS current is 10 A: average current over full cycle, average current over half cycle, RMS current, peak current.
- A.average current over half cycle
- B.peak current
- C.average current over full cycle
- D.RMS current
Show answer and explanation
Answer: A. average current over half cycle, B. peak current, C. average current over full cycle, D. RMS current
For a sinusoidal alternating current, let the peak current be .
Given:
For a sine wave,
So,
Now find each quantity:
1. Average current over full cycle:
For a complete sine-wave cycle, the positive and negative halves cancel each other.
2. Average current over half cycle:
For a sinusoidal current,
Substituting A,
3. RMS current:
4. Peak current:
So the numerical values are:
- average current over full cycle A
- average current over half cycle A
- RMS current A
- peak current A
Arranging from smallest to largest:
Therefore, the correct order is:
1. average current over full cycle
2. average current over half cycle
3. RMS current
4. peak current - Q8.In an AC heating experiment using the same resistor, arrange the following voltages in increasing order of heat produced in the same time interval: 50 V DC, 50 V RMS AC, sinusoidal AC of peak 50 V, 25 V RMS AC.
- A.50 V RMS AC
- B.sinusoidal AC of peak 50 V
- C.25 V RMS AC
- D.50 V DC
Show answer and explanation
Answer: A. 50 V RMS AC, B. sinusoidal AC of peak 50 V, C. 25 V RMS AC, D. 50 V DC
For the same resistor and the same time interval, the heat produced is given by Joule’s law:
So, for fixed and fixed , the heat produced is proportional to .
Therefore, we must compare the RMS values of all the given voltages.
1. V RMS AC
Its RMS value is already given:
2. Sinusoidal AC of peak V
For a sinusoidal AC,
3. V RMS AC
Its RMS value is:
4. V DC
A DC voltage is constant, so its effective (heating) value is the same as its actual value:
Now compare the RMS values:
Hence the increasing order of heat produced is:
So the last two produce equal heat. In an ordering question, when two items are equal, either order between those two is physically acceptable. Using the given option sequence, the correct increasing arrangement can be written as:
- 25 V RMS AC
- sinusoidal AC of peak 50 V
- 50 V RMS AC
- 50 V DC
The originally marked answer placed the equal pair in the reverse order. Since both give the same heating effect, that marked arrangement is not actually wrong in physics, but for a strict ordered output we provide one valid increasing sequence based on equality at the end. - Q9.A sinusoidal voltage is represented by . Arrange the following quantities in decreasing order when V: instantaneous voltage at , peak voltage, RMS voltage, average voltage over half cycle.
- A.average voltage over half cycle
- B.instantaneous voltage at
- C.peak voltage
- D.RMS voltage
Show answer and explanation
Answer: A. average voltage over half cycle, B. instantaneous voltage at , C. peak voltage, D. RMS voltage
For the sinusoidal voltage with V, evaluate each quantity:
1. Instantaneous voltage at :
2. Peak voltage:
The peak value of the sinusoidal voltage is simply
3. RMS voltage:
For a sine wave,
4. Average voltage over half cycle:
For a sine wave, average value over one half cycle is
So the values are:
- instantaneous voltage at = V
- peak voltage = V
- RMS voltage V
- average voltage over half cycle V
Hence, in decreasing order:
Therefore the correct arrangement is:
1. instantaneous voltage at
2. peak voltage
3. RMS voltage
4. average voltage over half cycle
Note: the first two quantities are equal, so their relative order may be interchanged mathematically. Since ordering questions usually require one sequence, the given arrangement is acceptable. - Q10.Arrange the following power quantities in a series AC circuit in increasing order for a fixed rms voltage and current: true power, reactive power, apparent power, when power factor is 0.6.
- A.reactive power
- B.apparent power
- C.true power
Show answer and explanation
Answer: A. reactive power, B. apparent power, C. true power
For fixed rms voltage and current, apparent power is , true power is , and reactive power is . Given power factor , we get . So , , and . Therefore, the increasing order is true power, reactive power, apparent power.
Practise all 348 Current Electricity and Magnetism – AC questions
Instant feedback, explanations, timed mock tests and progress tracking. Free on the web and Android.
More Physics chapters
- Current Electricity and Magnetism – Circuits MCQs472
- Current Electricity and Magnetism – Electrical Quantities MCQs313
- Current Electricity and Magnetism – Electromagnetic Induction MCQs472
- Current Electricity and Magnetism – Magnetic Field MCQs470
- Current Electricity and Magnetism – Magnetic Materials MCQs204
- Current Electricity and Magnetism – Thermoelectric MCQs256
- Electrostatics and Capacitors MCQs972
- Heat and Thermodynamics MCQs1,486
- Mechanics – Circular & Periodic Motion MCQs566
- Mechanics – Dynamics MCQs670
- Mechanics – Elasticity MCQs279
- Mechanics – Fluid Statics & Dynamics MCQs755
- Mechanics – Gravity MCQs497
- Mechanics – Kinematics MCQs362
- Mechanics – Physical Quantities & Vectors MCQs382
- Mechanics – Rotational Dynamics MCQs378
- Modern Physics – Electron MCQs390
- Modern Physics – Nuclear Physics MCQs481
- Modern Physics – Particle Physics & Recent Trends MCQs394
- Modern Physics – Photon MCQs312
- Modern Physics – Radioactivity MCQs498
- Modern Physics – Semiconductors MCQs485
- Modern Physics – Wave-Particle Duality MCQs582
- Waves and Optics – Acoustics MCQs310
- Waves and Optics – Diffraction & Polarization MCQs436
- Waves and Optics – Interference MCQs202
- Waves and Optics – Reflection & Refraction MCQs412
- Waves and Optics – Stationary Waves MCQs304
- Waves and Optics – Wave Motion MCQs368
