Heat and Thermodynamics MCQ questions with answers

CEE Entrance · Physics. Below are 10 sample questions from this chapter, each with the correct answer and an explanation. The full set of 1,486 questions is free to practise on Prashnalaya.

Topics covered: Concept of entropy, First law of thermodynamics: internal energy, work done, heat exchange, Heat capacity and specific heat capacity; calorimetry, Heat engine efficiency; Carnot's cycle, Latent heat of fusion and vaporization; triple point, Linear, superficial and cubical (volumetric) thermal expansion; calculations, Modes of heat transfer: conduction, convection, radiation, Molecular properties of ideal gas; kinetic interpretation of pressure and temperature, Real and apparent expansion of liquids, Refrigerator: working principle and coefficient of performance, RMS speed, mean speed, most probable speed; average kinetic energy, Second law of thermodynamics: Kelvin-Planck and Clausius statements, Thermal energy, heat and temperature: concepts and distinction, Thermodynamic processes: adiabatic, isothermal, isochoric, isobaric, Types of thermometers: liquid-in-glass, resistance thermometer, radiation thermometer, Zeroth law of thermodynamics; Stefan-Boltzmann law

  1. Q1.
    Arrange the following temperatures in increasing order of radiant power emitted per unit area by the same ideal black body, using Stefan-Boltzmann law.
    K
    K
    K
    K
    • A. K
    • B. K
    • C. K
    • D. K
    Show answer and explanation

    Answer: A. K, B. K, C. K, D. K

    By Stefan-Boltzmann law, the radiant power emitted per unit area of an ideal black body is

    where is emissive power, is the Stefan-Boltzmann constant, and is the absolute temperature in kelvin.

    Since the same black body is considered in all cases, is constant, so emitted power depends only on . Therefore, as temperature increases, radiant power increases very rapidly.

    Now compare the temperatures:

    Hence their fourth powers will also follow the same order:

    So the increasing order of radiant power emitted per unit area is:


    Thus the correct arrangement is:
    K K K K.
  2. Q2.
    A blackened metal sphere is heated successively to different temperatures in a lab. Arrange the temperatures in decreasing order of heat radiation rate from the surface, assuming area and emissivity remain constant.
    K
    K
    K
    K
    • A. K
    • B. K
    • C. K
    • D. K
    Show answer and explanation

    Answer: A. K, B. K, C. K, D. K

    For a blackened metal sphere, the rate of heat radiation from the surface is given by the Stefan-Boltzmann law:



    where:
    - = rate of radiation
    - = emissivity
    - = Stefan-Boltzmann constant
    - = surface area
    - = absolute temperature in kelvin

    Here, area and emissivity are constant, so:



    This means the radiation rate increases very rapidly with temperature. Therefore, to arrange the temperatures in decreasing order of radiation rate, we simply arrange them from highest temperature to lowest temperature:



    So the correct order is:
    - K
    - K
    - K
    - K

    Hence, the marked answer is correct.
  3. Q3.
    Arrange the following bodies in increasing order of total power radiated, assuming all behave as black bodies at the same temperature.
    Surface area unit
    Surface area units
    Surface area units
    Surface area units
    • A.Surface area units
    • B.Surface area unit
    • C.Surface area units
    • D.Surface area units
    Show answer and explanation

    Answer: A. Surface area units, B. Surface area unit, C. Surface area units, D. Surface area units

    For a black body, the total power radiated is given by the Stefan–Boltzmann law:

    where:
    - = total power radiated
    - = Stefan–Boltzmann constant
    - = surface area
    - = absolute temperature

    Here, all the bodies are black bodies and are at the same temperature. Since and are the same for all, we get:

    So the total radiated power increases directly with surface area.

    Therefore, the body with the smallest area radiates the least power, and the body with the largest area radiates the most power.

    Thus the increasing order of total power radiated is:


    Matching this with the given options, the correct order is:
    - Surface area unit
    - Surface area units
    - Surface area units
    - Surface area units
  4. Q4.
    A body is surrounded by an environment at temperature K. Arrange the following body temperatures in increasing order of net rate of heat loss by radiation, assuming same area and emissivity.
    K
    K
    K
    K
    • A. K
    • B. K
    • C. K
    • D. K
    Show answer and explanation

    Answer: A. K, B. K, C. K, D. K

    The net rate of heat loss by radiation for a body in surroundings at temperature is given by the Stefan–Boltzmann law:



    where:
    - = emissivity
    - = Stefan–Boltzmann constant
    - = area
    - = temperature of the body
    - K = temperature of surroundings

    Since the question says the bodies have the same area and emissivity, is constant for all cases. Also, all given temperatures K, K, K, and K are greater than K, so each body loses heat to the surroundings.

    Thus, the net rate of heat loss depends only on the value of:



    As increases, also increases. Therefore, the body with the lowest temperature has the smallest net radiative heat loss, and the body with the highest temperature has the greatest net radiative heat loss.

    So the increasing order of net rate of heat loss is:



    Hence the correct arrangement is:

    K, K, K, K.
  5. Q5.
    Arrange the following temperature values in increasing order of hotness: 0°C, 273 K, 32°F, 300 K
    • A.300 K
    • B.273 K
    • C.32°F
    • D.0°C
    Show answer and explanation

    Answer: A. 300 K, B. 273 K, C. 32°F, D. 0°C

    32°F = 0°C, and 0°C = 273 K approximately. So these three represent the same temperature, and 300 K is higher than them. Hence the increasing order is 32°F, 0°C, 273 K, 300 K.
  6. Q6.
    Arrange the following bodies in increasing order of thermal energy, assuming each is made of the same substance and has the same mass: 20°C body, 40°C body, 60°C body, 80°C body
    • A.60°C body
    • B.20°C body
    • C.80°C body
    • D.40°C body
    Show answer and explanation

    Answer: A. 60°C body, B. 20°C body, C. 80°C body, D. 40°C body

    For the same substance and same mass, greater temperature means greater internal or thermal energy. Therefore thermal energy increases as temperature increases. So the correct order is 20°C body, 40°C body, 60°C body, 80°C body.
  7. Q7.
    Arrange the following situations in increasing order of heat required to raise the temperature by the same amount, assuming no heat loss: 1 kg water, 1 kg copper, 1 kg iron, 1 kg aluminium
    • A.1 kg iron
    • B.1 kg aluminium
    • C.1 kg water
    • D.1 kg copper
    Show answer and explanation

    Answer: A. 1 kg iron, B. 1 kg aluminium, C. 1 kg water, D. 1 kg copper

    The heat required is given by . Since mass and temperature rise are the same, heat required depends only on specific heat capacity . Approximate values are: copper about 390 J/kg°C, iron about 450 J/kg°C, aluminium about 900 J/kg°C, and water about 4200 J/kg°C. Therefore the increasing order of heat required is 1 kg copper, 1 kg iron, 1 kg aluminium, 1 kg water.
  8. Q8.
    Arrange the following substances in increasing order of latent heat of fusion at atmospheric pressure: lead, ice, mercury, iron.
    • A.lead
    • B.ice
    • C.mercury
    • D.iron
    Show answer and explanation

    Answer: A. lead, B. ice, C. mercury, D. iron

    The latent heat of fusion is the heat required to convert unit mass of a solid into liquid at its melting point. Approximate values are: mercury about J/kg, lead about J/kg, iron about J/kg, and ice about J/kg. Therefore, the increasing order is mercury, lead, iron, ice.
  9. Q9.
    A fixed mass of water is heated from C to steam at C. Arrange the stages in the correct sequence in which heat is absorbed.
    • A.vaporization at C
    • B.heating water from C to C
    • C.heating ice from C to C
    • D.melting at C
    Show answer and explanation

    Answer: A. vaporization at C, B. heating water from C to C, C. heating ice from C to C, D. melting at C

    When ice at C is supplied heat, its temperature first rises to C. Then it melts at constant temperature, absorbing latent heat of fusion. After all ice becomes water, the temperature of water rises from C to C. Finally, water changes to steam at C by absorbing latent heat of vaporization. Hence the correct order is heating ice, melting, heating water, vaporization.
  10. Q10.
    Arrange the following amounts of heat required in increasing order for 1 kg of water-related sample at 1 atm: latent heat to melt ice at C, heat to raise water from C to C, latent heat to vaporize water at C, heat to raise ice from C to C.
    • A.latent heat to vaporize water at C
    • B.heat to raise water from C to C
    • C.latent heat to melt ice at C
    • D.heat to raise ice from C to C
    Show answer and explanation

    Answer: A. latent heat to vaporize water at C, B. heat to raise water from C to C, C. latent heat to melt ice at C, D. heat to raise ice from C to C

    For 1 kg: heat to raise ice by C is J. Latent heat to melt ice is about J. Heat to raise water from C to C is J. Latent heat to vaporize water is about J. Thus increasing order is: heating ice from C to C, melting, heating water from C to C, vaporization.

Practise all 1,486 Heat and Thermodynamics questions

Instant feedback, explanations, timed mock tests and progress tracking. Free on the web and Android.

Start practising free

More Physics chapters

All CEE Entrance subjects →